Updating the Hub

1763 views 1

Downloading an update

ThinPrint Hub’s firmware updates can be found on the ThinPrint Clients & Tools downloads page under the heading Hub Firmware:

  • Compare the firmware versions there with that listed in the web console of the respective Hub.


Note: As of firmware version 1.8, Hubs or Release Stations are automatically connected to the NoTouch Center when they can reach it. These newly registered Hubs are added to the Unassigned group, which does not yet overwrite their previous settings. See also Assigning Hubs or Release Stations.

Alternatively you can use:

initiate firmware update

Installing a firmware update

A downloaded firmware updated can be imported to the Hub – either

Note! Carry out a precautionary backup beforehand; see Backup and Restore or Export-TPHubBackup.
Note! Finally, perform a system reboot. To do so, disconnect the device from the power supply, wait for half a minute and then reconnect it.

Previous Page
Next Page

Was this helpful?