Open navigation

NoTouch Center group management

Group menu

Buttons

Configuration tab

Actions tab

Acl tab

Info tab

Licenses tab

Group Settings menu


The NoTouch Center's group management allows you to configure and manage groups of ThinPrint Hubs identically. This is necessary, for example, if load balancing has been set up between two or three hubs.

The following describes only those functions that apply exclusively to the groups. Functions that are the same for hubs and groups can be found in the Managing Hubs section.


Group menu

Buttons

  • The group menu opens when you select the name of a group, e.g. Netherlands.

On-premises remote ThinPrint Hub management using the NoTouch Center: Group menu

Here you will find the following buttons in the upper right corner: 

 

add an unassigned Hub to this group
rename this group
add a subgroup tothis group
delete this group


Configuration tab

Administration

You have the following input and selection options in this menu:

Descriptiondescription field for this group
Firmware Pool URLsee Multiple image pools in the Stratodesk knowledge base
Assigned toassignment of this group to a higher-level group; this can be changed here

On-premises remote ThinPrint Hub management using the NoTouch Center: Configurations tab

Automatic assignment

For Automatic assignment see the article Auto-assign of the Stratodesk knowledge base.


Actions tab

  • On the Actions tab, you can reboot the Hubs of a group, announce them to the NoTouch Center, reset the authentication key (Mkey Auth Token), or perform the automatic assignment to a group again (Re-run Autoassign).
  • Confirm with Execute.

On-premises remote ThinPrint Hub management using the NoTouch Center: Actions tab


Acl tab

  • On the Acl tab you can assign the users of the NoTouch Center one of the rights Read or Write for this group.
    All rights set here are inherited to both subgroups and Hubs. Therefore, they cannot be changed there.
  • Confirm with Save.

On-premises remote ThinPrint Hub management using the NoTouch Center: ACL tab

Acl stands for Access Control List


Info tab

  • The Info tab displays the hubs of this group or of a subgroup with status, IP address and firmware version.
  • Click on  to show details of the Hubs.

On-premises remote ThinPrint Hub management using the NoTouch Center: Info tab


Licenses tab

The Stratodesk licenses shown here are not relevant for ThinPrint Hubs.

See the Licensing section instead.


Group Settings menu

The settings in the Group Settings menu correspond to those of the individual hubs, but are made here for groups of hubs.

For the individual functions of this menu, see the section Managing Hubs.

On-premises remote ThinPrint Hub management using the NoTouch Center: Group Settings menu


Did you find it helpful? Yes No

Send feedback
Sorry we couldn't be helpful. Help us improve this article with your feedback.